12
US
Setting up the amplifier
SONY TA-MR2ES (US) 2-514-603-12(1)
Setting up the IR ID
You can set up the IR ID when the IR ID TEST switch is in
the “ON” or “OFF” position.
When the IR ID TEST is “ON”
Select this setting to teach the six IR codes below to any
IR-based controller.
IR TEST buttons
Function
POWER ON/OFF
To turn on or off the power.
POWER ON
To turn on the power.
POWER OFF
To turn off the power.
MUTING
To mute the sound.
VOL –
To turn down the volume.
VOL +
To turn up the volume.
1
Make sure that the ATTENUATOR L/R is adjusted to
minimum. For details, refer page 14.
2
Turn on the amplifier.
3
Set the IR ID TEST switch to the “ON” position.
The IN USE indicator flashes.
4
To output the IR code, for example ID1, set the IR
ID 1 switch to the “ON” position and set the rest of
the IR ID switches (IR ID 2, 3 and 4) to the “OFF”
position. To select other IR ID, refer to the table
below.
1
2
3
4
ID1
ON
OFF
OFF
OFF
ID2
OFF
ON
OFF
OFF
ID3
ON
ON
OFF
OFF
ID4
OFF
OFF
ON
OFF
ID5
ON
OFF
ON
OFF
ID6
OFF
ON
ON
OFF
ID7
ON
ON
ON
OFF
ID8
OFF
OFF
OFF
ON
ID9
ON
OFF
OFF
ON
ID10
OFF
ON
OFF
ON
ID11
ON
ON
OFF
ON
ID12
OFF
OFF
ON
ON
If you set the IR ID other than those listed in the table
above, the IR ID will automatically be set to ID1.
IR ID
4
3
2
1
TEST
OFF
ON
H
X
m
M
.
>
-
x
P
L
O
f
F
G
g
IR TEST
IR ID
AUTO POWER SELECTOR
12V TRIGGER
IR REMOTE
AUDIO
R
R
L
IN
OUT
IN
IR IN
4
3
2
1
TEST
12V TRIGGER
IR IN
AUDIO SENSING
OFF
ON
VOL
VOL
POWER
OFF
POWER
ON
POWER
ON / OFF
MUTING
IR OUT
OUT
L
SPEAKERS
AC IN
IR emitter
Learning remote
5
Plug the IR emitter to the IR REMOTE IR OUT jack of
the amplifier.
6
Make sure the learning remote has been set to
learning mode and the IR emitter is touching the
learning remote.
7
Press the IR TEST button for the code you want to
learn.
For example, if you want to learn power on/off, press
POWER ON/OFF.
The IN USE indicator flashes faster. It takes about 2.5
seconds to complete the learning. During this time, if
you press other buttons, they will not function.
If learning is not completed, repeat steps 6 and 7.
6
Repeat steps 6 to 7 to learn other buttons.
You can then use the remote to operate the amplifier.
Tips
• Make sure that the IR ID TEST switch is set to the “OFF”
position and the IR ID switches is set correctly before using the
remote to operate the amplifier. When the IR ID TEST switch is
set to “OFF”, the amplifier will turn on at the previous
operating condition.
• For details on setting the learning remote to learning mode,
refer to the operating instructions supplied with the remote.
01US04CH2-U.p65
11/30/04, 1:08 PM
12
