21
To cancel the setting
In step
7
, instead of pressing the CLOCK SET button,
press the U ID SET, EJECT, TEST, or SEARCH
button, or any of the tape transport buttons.
Setting the User ID
1
After checking the points below, turn the POWER
switch ON.
The following will appear in the LED display.
When in DATE/U ID mode:
Date/Time
a)
User ID (2 digits)
When in U ID mode:
User ID (12 digits)
a) See previous page to set date and time.
2,6
3,5
1
1
4,5
6
0
0
p
“
r
Where to check
What to check for
Lithium battery
compartment
That the lithium battery is properly
installed.
(See page 18.)
BATTERY switch
Set to ON if the date and time
settings are to be saved.
LED display
switch
That it is set to the desired setting
(DATE/U ID or U ID).
When the LEDs are blinking
The battery is exhausted. Please replace it with a
new battery. If the battery’s power is completely
used up, the ID data that has been saved will be
lost.
2
Press the U ID SET button.
The leftmost digit of the User ID begins to blink.
3
Pressing the INC or DEC button, set the blinking
digit to the value desired.
4
Press the SHIFT button to have another digit blink.
5
Repeat steps
3
and
4
and set all digits to the values
desired.
6
Press the U ID SET button again.
The User ID that has set will be stored.
To correct the values
Before pressing the U ID SET button in step
6
, press
the SHIFT button to have the desired digit blink, then
correct the value using the INC and DEC buttons.
To cancel the setting
In step
6
, instead of pressing the U ID SET button,
press the CLOCK SET, EJECT, TEST, or SEARCH
buttons, or any of the tape transport buttons.
Front
Rear
Содержание SVRM-911
Страница 47: ......
