Sony STR-V424, Руководство по эксплуатации

Страница: 5 / 29

5
GB
Getting Started
Aerial Hookups
Overview
This section describes how to connect AM and FM
aerials to the receiver. If you want to receive radio
broadcasts with the receiver, complete these
connections first, then go to the following pages.
For specific locations of the terminals, see the
illustration below.
What aerials will I need?
Hookups
FM wire aerial
If you have poor AM reception
Connect a 20 to 50 ft. (6 to 15-meter) insulated wire (not
supplied) to the AM aerial terminal in addition to the
AM loop aerial. Try to extend the wire outdoors and
keep it horizontal.
Connecting a ground wire
If you connect the receiver to an outdoor aerial, ground
it against lightning as shown in the illustration in the
left column. To prevent a gas explosion, do not connect
the ground wire to a gas pipe.
Note (except STR-V424)
Do not use the SIGNAL GND y terminal for grounding the
receiver.
Where do I go next?
If you want to connect other components, go on to the next
section. If you’re only planning to use the receiver to listen
to the radio, go to “Speaker System Hookups” on pages 7
and 8.
Audio Component Hookups
Overview
This section describes how to connect your audio
components to the receiver. If you want to use the
receiver as an amplifier, complete these connections.
For specific locations of the jacks, see the illustration
below.
What cables will I need?
Audio cords (not supplied) (1 for each CD player or
turntable; 2 for each MD recorder or tape deck)
• AM loop aerial
(supplied) (1)
• FM wire aerial
(supplied) (1)
After connecting
the wire aerial,
keep it as
horizontal as
possible.
If you have poor FM reception
Use a 75-ohm coaxial cable (not supplied) to connect the
receiver to an outdoor FM aerial as shown below.
Receiver
AM loop aerial
Receiver
(continued)
Red (R) Red (R)
White (L) White (L)
COAXIAL
FM
75
Ω
AM
y
ANTENNA
COAXIAL
FM
75
Ω
AM
y
ANTENNA
Ground wire
(not supplied)
To ground
FM outdoor aerial
CD MD/TAPE
y
(STR-V525 only)
PHONO
(STR-V525 only)
CTRL A1 II (STR-V525 only)
ANTENNA y (STR-V525 only)