122
GB
D:\NORM'S JOB\SONY HA\SO0062\STR-DN1010\GB\GB07ADD_STR-DN1010-CEL.fm
masterpage: Left
STR-DN1010
4-174-068-
11
(1)
Troubleshooting
If you experience any of the following
difficulties while using the receiver, use this
troubleshooting guide to help you remedy the
problem. Should any problem persist, consult
your nearest Sony dealer.
There is no sound, no matter which
component is selected, or only a very
low-level sound is heard.
• Check that the speakers and components
are connected securely.
• Check that all speaker cords are connected
correctly.
• Check that both the receiver and all
components are turned on.
• Check that MASTER VOLUME control is
not set to “VOL MIN”.
• Check that the SPEAKERS is not set to
“SPK OFF” (page 37).
• Check that headphones are not connected
to the receiver or S-AIR surround
amplifier.
• Press MUTING (RM-AAP051 only) or
(RM-AAP052 only) on the remote to
cancel the muting function. You can also
use MUTING on the receiver.
• Check that you have selected the correct
component with the input buttons
• The protective device on the receiver has
been activated. Turn off the receiver,
eliminate the short-circuit problem, and
turn on the power again.
There is no sound from a specific
component.
• Check that the component is connected
correctly to the audio input jacks for that
component.
• Check that the cord(s) used for the
connection is (are) fully inserted into the
jacks on both the receiver and the
component.
There is no sound from one of the front
speakers.
• Connect a pair of headphones to the
PHONES jack to verify that sound is
output from the headphones. If only one
channel is output from the headphones, the
component may not be connected to the
receiver correctly. Check that all the cords
are fully inserted into the jacks on both the
receiver and the component. If both
channels are output from the headphones,
the front speaker may not be connected to
the receiver correctly. Check the
connection of the front speaker which is
not outputting any sound.
• Make sure you have connected to both the
L and R jacks of an analog component, and
not only to either the L or R jack. Use an
audio cord (not supplied). However, there
will be no sound from the center speaker
when a sound field (2ch Stereo, etc.) is
selected. When the center speaker is not
connected, sound is output only from the
front left/right speakers.
There is no sound from analog 2
channel sources.
• Check that the selected digital audio input
jack is not assigned to other inputs in
“Input Assign” in the Input Option menu
(page 85).
• Check that the INPUT MODE is not set to
“AUTO” (page 84) and the “Input Assign”
function is not used to reassign the audio
input of another source to the selected
input (page 85).
• Check that the INPUT MODE is not set to
“AUTO” (page 84) and the DIGITAL
connection is not made for the selected
input.
Audio