Sony SSC-SD26P, Руководство по эксплуатации, Страница: 6 / 40

O
u
tline
Component Diagram / Connections and setup / Cold Start
6
Component Diagram
1 Composite video cable (BNC cable)
2 Alarm input line
3 Alarm output line
4 AC 24V power cable (with ground line)
5
RS-485 signal line (not supplied with adapter)
6 fastener (not supplied)
7 Cable
8 Sun shield (optional)
9 Connector ring
0 Water-proof cover
qa
Main unit
qs lens
qd Water-proof transparent housing
qf Safety cable
Connections and setup
Cold Start
When the camera is started in low temperature, it may
operate improperly due to low inner temperature.
Therefore, cold start operation should be performed if it
is necessary to start the camera in the envionment of –40
to –5 due to blackouts or other reasons.
Cold Start procedures
1
Turn on the power, and turn off the camera after the
heater operates for 1 hour, and then turn off.
2
Turn on the camera again.
6
7
8
9
0
qa
qs
qd
qf
1
2
3
4
5
Monitor
Alarm
inputs
Keypad controller (not
supplied)
AC 24V power adapter
Alarm
outputs
RS485
GND
Alarm In 1
Alarm In 2
Alarm In 3
Alarm In 4
Alarm In 5
Alarm In 6
GND
GND
Alarm Out Open
Alarm Out Com
Alarm Out Close
Grounding line (black)
Alarm input line 1 (brown)
Alarm input line 2 (red)
Alarm input line 3 (orange)
Alarm input line 4 (yellow)
Alarm input line 5 (green)
Alarm input line 6 (blue)
Grounding line (purple)
Grounding line (grey)
Alarm output normal ON (white)
Alarm output Com (sky-blue)
Alarm output normal OFF (pink)
Adapter (not supplied)