Sony SRX-T105, Руководство по установке

Страница: 18 / 44

18
Connecting the AC Power Cord
Chap
te
r 2
I
n
s
ta
llat
ion
a
nd Conn
ec
tio
n
s
Connecting with Component/Video
GBR Equipment
Attach the optional LKRI-001 analog input board to the
input board attachment part on the projector, and connect
with a DVD recorder/player or analog video equipment
equipped with the component output, or an high-definition
equipment equipped with a video GBR connector.
When connecting to the output of HD component
equipment, set “Signal Mode” of “Input Source” in the
PICTURE CONTROL window to “YPbPr”, and when
connecting to the output of HD video GBR equipment, set
to “RGB”.
For details, see page 25.
Connecting the AC Power
Cord
Use an AC power cord that supports 8AWG, 250 V, 40 A
or higher.
Follow the steps below to connect the three-wire power
cord to the AC IN terminal on the left side of the projector.
• Connection of the main power and the electric wiring
work should be done by qualified electricians only.
• Do not plug the power cord into the power supply before
completing the following operations.
1
Remove the two screws on the terminal cover and
remove it.
2
Remove the two screws on the cable clamp and
remove it.
3
Pass the AC power cord through the hole beneath the
terminal, and tighten the screw for each wire as
illustrated.
Note
R(Pr/Cr) B(Pb/Cb) HD VD G(Y/Y)
IN
INTER LOCK ETHERNET RS232C
OUT
IN OUT
AUX DVI-D
R/P
r
/ G/Y / B/P
b
connectors
Component cable, etc
(not supplied)
Betacam, DVD recorder/player, etc.
Left side
to component output/
video GBR
WARNING
N
L
Cable clamp
N
L
N
L