Sony SRG-300SE, Руководство пользователя

Страница: 47 / 68

O
per
a
tio
n U
s
in
g th
e
Re
mot
e
C
o
nt
rolle
r
47
Preparation
Operation Using the Remote
Controller
This section explains the operations of the camera using
the remote controller.
When you make the settings of the camera using the
remote controller, see “Setting with the Remote
Controller” on page 52.
When you operate the camera via a network, see
“Operating the Camera Via a Network” on page 11.
Before operating, check that the camera, the remote
controller, and peripheral devices are properly installed
and connected.
For details, see “Installation Manual” and “System
Configuration” on page 6.
Notes
• You can select the IP connection and the serial
connection (RS-422) for the connection between the
camera and the remote controller. For details, see
“Setting the Camera Via a Network” - “Configuring
the Network — Network Menu” - “Network Tab” on
page 29. Set the communication speed of the VISCA
RS-422 connector of the connected camera using the
serial connection to be the same speed of the remote
controller. For details, see “Setting the Camera Via a
Network” - “Setting the PTZF control — PTZF
control Menu” - “Serial Tab” on page 43.
• Do not operate the camera via a network or use the
remote controller at the same time.
• When performing the IP output of video and audio, the
response of the camera to operation from the remote
controller may delay.
• For details of the remote controller settings, see the
Operating Instructions of the remote controller.
Preparation
1
Connect the camera to an AC outlet using the
supplied AC power adaptor.
The power is turned on and the POWER indicator
and the NETWORK indicator lights or flashes.
About 2 minutes after turning on the power, the
camera will automatically reset to the pan/tilt
position and the camera settings stored in
POSITION 1 (Preset 1).
For the setting items retained in the memory when
starting the camera, see “Preset Items” on page 63.
2
Press the ON/OFF switch on the remote controller
to turn it on.
The CAMERA button representing the camera
whose power was turned off last lights.
(The CAMERA 1 button lights by default.)
3
Turn on the peripheral devices.
Notes
• Be sure to turn on the power of the camera before the
power of the remote controller. Otherwise, the remote
controller may not recognize the connected camera.
• After turning on the power of the camera, wait more
than two minutes and turn on the power of the remote
controller. Otherwise, the connection may not be
recognized. Also, you cannot turn on/off the power of
the camera from the remote controller.
1
LOCK
JOYSTICK
KNOB
MODE
VALUE
RESET
POSITION
GROUP
MENU GROUP
PRESET
SHIFT
BLACK
LIGHT
PAN-TILT
RESET
ONE PUSH
AWB
POWER
SELECT
AUTO
MANUAL
AUTO
ONE PUSH
AF
2 3 4 5 6 7
POSITION
CAMERA
GROUP
R
– +
BRIGHT
B
– +
FOCUS
NEAR FAR
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16
1 2
POWER CAMERA
RESET