3
SRF-HM03V
SECTION 1
GENERAL
This section is extracted from
instruction manual.
POWER ON/OFF
Driver Unit
TUNE +
*
2
/—
Display
MEGA BASS/CLOCK
ENTER
MODE
BAND
VOL*
1
TV/WB/FM SENS
DX/LOCAL
R
(Right)
L
(Left)
Battery
compartment lid
Light reflector (L)
This reflector
reflects car lights
at night for your
safety.
*
1
There is a tactile dot beside volume to show the
direction to turn up the volume.
*
2
The TUNE + button has a tactile dot.
Setting the Clock
The clock time display of this unit is a 12-hour system.
When the battery is first installed, AM 12:00 flashes in the display.
1
Set
POWER
to
OFF
to turn off the power.
2
Hold down
MEGA BASS/CLOCK
for more than 2 seconds
until AM 12 starts flashing.
3
Press
TUNE +
or
–
to adjust the hour, then press
MEGA BASS/
CLOCK
.
If you hold down
TUNE +
or
—
, the digit changes rapidly.
AM 12:00 = midnight, PM 12:00 = noon.
4
Repeat step
3
above to adjust the minute.
: starts flashing and the clock starts operating.
To set the current time exactly to the second, adjust the minute and then press
MEGA BASS/CLOCK
to synchronize with a time signal (such as the
telephone time signal).
Note
If you do not press
TUNE +
or
—
, or
MEGA BASS/CLOCK
within one minute,
the clock setting mode will be canceled.
Wearing the Headphone
Radio
(See fig
A
)
1
Wear the
L
side driver unit in your left ear and the
R
side in your
right ear as illustrated.
2
Adjust the position of the driver units for a comfortable fit.
Changing AM Channel Step
The AM channel step differs depending on areas. The channel step of this unit is
factory-set to 10 kHz. Change the settings as shown below to be able to listen to
the radio.
Area
Channel step
North and South American countries
10 kHz
Other countries
9 kHz
Note
When the AM channel step is changed, only the preset stations on the AM band
will be initialized.
1
Set
POWER
to
OFF
to turn off the power.
2
While holding down
MODE
, hold down
TUNE +
or
–
for more
than 5 seconds.
The channel step will change and 9 kHz (or 10 kHz) will flash for 3
seconds in the display.
If you proceed to step
2
again, the channel step changes again.
Light reflector (R)
A
