Sony SPP-ID970 - Cordless Telephone, Руководство по обслуживанию

Страница: 33 / 42

– 3 – – 4 –
J1
frequency
counter frequency
counter
J1003
J1004
BATTERY
3.6V
U1001
C1031
C1030
48pin
C1029
– HAND MAIN BOARD –
– RF UNIT (HS) –
2) HANDSET
1. Test Mode
Entry— Press “PGM” key and enter “ TEST” on keypad.
Alternative entry— Write 99h into LSB of location 9 in EEPROM.
Exit— Press on “OFF” key.
LCD test— Press the “7” key.
Toggle TX power— Press the “0” key.
Increment RF channel— Press the “#” key.
2. Test Equipment Required and Connection
3. Verify Procedure
Item Remark
18.4MHz Frequency Error Connect the frequency counter to the test point J1, press “0” key to turn on the TX power. Then, check
the frequency ± 1 kHz. If the result is within ± 1 kHz, then no adjustment required. Otherwise, refer to
item 4. for Adjustment Procedure.
4. Adjustment Procedure
Item Adjustment Element Remark
18.4MHz Frequency Error C1030 1. Remove C1031 from the HAND MAIN board.
2. Solder an 20PF chip capacitor C1030 (1-164-160-11) on the
HAND MAIN board (in parallel of C1029).
3. Connect the frequency counter to the U1001 pin
rk
. Adjust for 0 Hz ± 1 kHz.
* *
3) BASE UNIT
1. Test Mode
Entry— Simultaneously press the “HANDSET LOCATOR” key and toggle the “DIAL MODE” switch. When in test mode, the “LINE” and
“CHARGE” LEDs will be light on.
Alternative entry— Write 99h into LSB of location 9 in EEPROM.
Exit— Remove the AC power adaptor.
Toggle TX power— DIAL MODE switch (S2001)
T (TONE) position : TX ON
P (PULSE) position : TX OFF
Increment RF channel— Press the “HANDSET LOCATOR” key.
2. Test Equipment Required and Connection
3. Verify Procedure
Item Remark
18.4MHz Frequency Error Connect the frequency counter to the test point J1, press “0” key to turn on the TX power. Then, check
the frequency ± 1 kHz. If the result is within ± 1 kHz, then no adjustment required. Otherwise, refer to
item 4. for Adjustment Procedure.
4. Adjustment Procedure
Item Adjustment Element Remark
18.4MHz Frequency Error C2016 1. Remove C2017 from the BASE MAIN board.
2. Solder an 20PF chip capacitor C2016 (1-164-160-11) on the
BASE MAIN board (in parallel of C2015).
3. Connect the frequency counter to the U2001 pin rk . Adjust for 0 Hz ± 1 kHz.
J1
frequency
counter frequency
counter
– BASE MAIN BOARD
(SIDE B) –
– RF UNIT (BU) –
U2001
C2017
C2015
48pin
C2016
– BASE MAIN BOARD
(SIDE A) –