Sony SLV-ED100ME, Руководство по обслуживанию

Страница: 84 / 135

7-1
SECTION 7
ADJUSTMENTS
SLV-ED100/EZ2000/K990/KH9
7-1. MECHANICAL ADJUSTMENTS
Refer to the SERVICE MANUAL of VHS MECHANICAL AD-
JUSTMENT VI.
7-2. ELECTRICAL ADJUSTMENTS
2-1. PRE-ADJUSTMENT PREPARATIONS
Necessary items and indications for total adjustment of electric
circuit of this machine will be described in this chapter.
2-1-1. Instruments to be Used
1) Color TV
2) Oscilloscope 1 or 2 phenomena, band more than 30 MHz, de-
lay mode, as provided.
3) NTSC pattern generator
4) PAL pattern generator
5) Digital voltmeter
6) Audio level meter
7) Audio noise meter
8) Audio generator
9) Attenuator
10) Alignment tape
Part Code: 8-192-605-36 KRV-51P (PAL)
Part Code: 8-192-605-32 KRV-51N2 (NTSC)
2-1-2. Connection
Unless otherwise specified, connect and adjust the measuring in-
struments as shown in the following diagram.
Fig. 7-2-1
During the adjustment, see the Parts Arrangement
Diagram for Adjustments on Page 7-6.
Video output
(75
Ω
)
Pattern generator VCR
VIDEO LINE IN
Monitor TV
VIDEO LINE OUT
Fig. 7-2-2
2-1-4. Alignment Tapes
[Alignment Tape (KRV-51N2/KRV-51P)]
PAL
NTSC
1
2
3
4
Mode
SP
SP
EP
EP
Video signal
Color bar
Monoscope
Color bar
Monoscope
Audio signal
(HiFi/Normal)
400 Hz
Time
Seven minutes
Three minutes
Seven minutes
Three minutes
2-1-3. Set-up of Adjustment
In this adjustment, PAL or NTSC pattern generator is connected
with LINE input signal terminal. When checking with tuner, con-
nected AERIAL terminal. Check that the amplitudes of video sig-
nal SYNC signal, of picture portions, and of burst signals are flat
at approximately 0.3, 0.7 and 0.3 V, respectively, and that the level
ratio of the burst signal and “red” signal are 0.30: 0.66. Fig. 7-3-2.
shows video signals (color bars) used in adjusting the video sec-
tion.