Sony RMU-01, Руководство по эксплуатации

Страница: 18 / 26

18 Using the RMU-01 Setting Tool
To flash the POWER indicator
of the selected device
Click the Start button at the right of the
“Power LED Blink” indication.
The POWER indicator of the selected
device flashes at 0.1-second intervals for
about five seconds.
For details on the status of this unit and the POWER
indicator status, see “On the Status of This Unit and
the Lighting Status of the POWER Indicator” on
page 22.
To perform self-check for the
selected device
Click the Start button at the right of the
“Self Check” indication.
The check starts and the results of the
following four items (
1
to
4
) are
displayed.
1) When the 2.4-GHz wireless communication is
busy, self-check may not be performed
properly. In this case, “NG!” may be displayed
as the results. It is recommended that you
perform the check again after turning off the
transmitters and the receivers or after
disconnecting them from the network.
If results of any of the item from
1
to
3
in
the table above are “NG!”, the hardware of
the RMU-01 may be malfunctioning. If this
happens, consult your Sony service
representative or nearest dealer.
When a time-out error occurs in LAN
communication, “NG!(ErrCode 0xFF)”
appears as the results. This may be caused
by improper connection of the LAN cable
or inappropriate connection between this
unit and the power source. If this happens,
check the connection and the power source,
then perform the check again.
To resume the main display
Click the Close button (×) in the top-right
corner of the window.
Item Meanings
1
EEPROM test EEPROM check
2
Flash ROM test Flash ROM check
3
RM module test 2.4-GHz
transmission/
reception module
check
1)
4
Power Source
is Shows the power
source.
PoE : PoE
AC : AC adapter