19
Operation
Registering the connected component
The following procedure lets you setup the component
commander to operate the components connected to the
receiver.
When carrying out this operation, make sure that the receiver’s
power is on, and be sure to point the commander’s transmitter/
receiver section toward the display on the receiver.
1
Touch SETUP.
The SETUP screen appears.
2
Touch FUNCTION&USER IR.
The FUNCTION&USER IR screen appears.
3
Select the function that you wish to register (Ex:
VCR).
To display other items, use the JOG DIAL or touch
4
or
$
to scroll through the list.
The FUNCTION&USER IR:CATEGORY screen
appears.
4
Select the type of component connected (Ex: Sony
VTR1).
To display other items, use the JOG DIAL or touch
4
or
$
to scroll through the list.
The FUNCTION&USER IR:MAKER CODE screen
appears.
5
Touch the remote controller mode of the connected
component.
The component selected in steps 4 to 5 will be
registered at the function selected in step 3, and the
SETUP screen will reappear. A long beep sound is
emitted to indicate that registration was successful.
Operation is now possible from the FUNCTION
screen.
If a series of short beeps is emitted, redo the
registration procedure. If this occurs, make sure the
receiver is turned on and that the commander is
pointing toward the receiver during operation.
To stop registration at any time
Touch EXIT during step 2 or touch CANCEL during steps 3 to 5.
Notes
• All icons may not be displayed when registering components
made by certain manufacturers.
• Some icons may not function even though they are displayed
when registering components made by certain manufacturers.
