1-6
RM-PP1
Intermediate rail
Slide
Front
Ball retainer
17. Slide the unit in and out from the rack about three
times and check that the slide rails move smoothly.
If they are not smoothly, demount the unit and go back
to “Attaching the outer rails” (step 6).
c
When demounting the unit, carry it by the two persons
or more.
n
This unit does not have the feet at this operating.
Put down the unit on the floor or other, being careful
not to damage the unit.
18. Secure the unit to the rack with the four screws (RK5
x
20) and four ornamental washers.
Tightening torque: 120
x
10
_
2
N
.
m {12.2 kgf
.
cm}
Rack
Ornamental
washers
Ornamental
washers
RK5
x
20
RK5
x
20
1-5. Rack Mounting
.
Mounting in rack
c
Be sure to carry the unit by the two persons or more.
13. Set each ball retainer to the position as shown in the
figure.
14. Pull both intermediate rails by equal length.
15. Slowly insert the inner rails into the intermediate rails.
16. Slowly push the unit into the rack while pressing each
stopper .
c
Be careful not to catch your finger or hand in rack
mount rail.
Intermediate rail
Stopper
Stopper
Inner rail
