18
HEADPHONE/REMOTE CONTROL
120
18
Headphone/Remote Control
18.1
Audio Input
18.2
Serial Communications
The PSP communicates with the microcontroller inside the remote control using RS232 serial communication (although the voltages
are different of course, 0V and +2.5V) using 8N1 framing at 4800bps. The protocol consists of command packages which can be send
by either the PSP or the remote control. A package is exchanged as follows:
Sender
Reciever
description
0xF0
Request to transmit
0xF8
Clearance to transmit
0xFD
Packet starts
cmd
Command code + phase
params
Zero or more bytes of parameter data
checksum
XOR of the cmd and params bytes
0xFE
Packet ends
0xFA/0xFB
Packet received correctly
If the packet is not received correctly, or the receiver is too busy to allow the packet to be transmitted, the corresponding 0xFA/0xFB/0xF8
is not sent, in which case the sender should wait a while (60 ms) and then try again from the 0xF0. If no answer is received in a long
time (> 1s), a BREAK can be sent to reset the communication channel, after which the state should be the same as if the remote control
had been disconnected and reconnected again.
The least significant bit of the cmd byte is the phase indicator, which is used to differentiate a new command from the retransmission
of an old one. The first packet sent from a particular device has phase 0 (LSB = 0), and is acknowledged with 0xFA. Then the phase
is inverted each time a new packets is sent. Packets with phase 1 are acknowledged with 0xFB. Phase is not shared, so when the PSP
sends a packet it does not affect the phase of the remote control, and vice versa.
Note that there seems to be no particular way to know how many parameter bytes are contained in the message, as the parameter bytes
or the checksum could contain an 0xFE as well. It is therefore necessary to know how many parameter bytes each command takes.
The command sent by the remote control to inform the PSP of what buttons are pressed is 0x84. It takes two parameter bytes, which if
interpreted as a 16-bit integer (little endian) forms a bitfield like so:
bit
value
button
0
0x0001
Play/Pause
1
0x0002
? (unused)
2
0x0004
Fast Forward
3
0x0008
Rewind
4
0x0010
Vol +
5
0x0020
Vol -
6
0x0040
? (unused)
7
0x0080
Hold
Buttons that are pressed have their corresponding bits set to 1. Buttons that are not pressed or do not exist have their correspond-
ing bits set to 0.
The 0x80 command has some parameter bytes, and I’m guessing these are used to identify the type of device connected. There could
also be any number (well, a bit over 100 at least) of commands to request specific kinds of services from the PSP.
Содержание PlayStationPortable
