Sony PCS-1 - Video Conferencing Kit, Руководство по эксплуатации, Страница: 54 / 284

54
Registering Local Information
On: Enables the SNMP agent service.
Off: Disables the SNMP agent service.
Trap Destination
Enter the address of the trap destination
SNMP manager.
Community
Enter the community name managed by the
SNMP manager (up to 24 characters). The
default setting is “public”. Normally, there is
no need to change.
Description
Enter the description of this terminal. The
default setting is “Videoconference Device”
and cannot be changed.
Location
Enter the location where this terminal is
installed (up to 30 characters).
Contact
Enter information on the administrator of
this terminal (up to 30 characters).
Page 4/11
NAT Mode
Selects whether you connect the system to a
network using NAT (Network Address
Translation) that enables sharing of one IP
address for multiple computers on the same
LAN.
On: Enables the NAT mode when you
connect the system to a network using
NAT. With this option, set the NAT
address.
Off: Disables the NAT mode when you
connect the system to a network without
using NAT.
Auto (UPnP): Enables or disables the NAT
mode by automatically detecting the use
of NAT. This option is effective only
when you use the UPnP router.
NAT Address
Enter the IP address of a global network to
be used for NAT mode.
Packet Resend Request
Selects whether or not to request to resend
the packet when a packet loss occurs during
communication.
On: Requests resending a packet.
Off: Does not request resending a packet.
Adaptive Rate Control
Sets whether or not to always optimize the
LAN bandwidth.
On: Always optimizes.
Off: Disables optimization of the LAN
bandwidth.
This item is enabled only when “Packet Resend
Request” is set to “Off”. When “Packet Resend
Request” is set to “On”, this item is always set
to “On”.
LAN Mode
Selects the interface type and the
communication mode of the LAN
connection.
Auto Negotiation: The interface type and
the communication mode are recognized
automatically.
100Mbps Full Duplex: Connects via
100BASE-TX in full duplex mode.
100Mbps Half Duplex: Connects via
100BASE-TX in half duplex mode.
10Mbps Full Duplex: Connects via
10BASE-T in full duplex mode.
10Mbps Half Duplex: Connects via
10BASE-T in half duplex mode.
LAN Setup
LAN Mode
Auto Negotiation
Page: 4/11
Off
On
NAT Mode
NAT Address
Packet Resend Request
Adaptive Rate Control
Save Cancel
On
Note