7
0
AUT
OMA
TED FUNCTIONS
1
SENSOR AND LENS
2
SHOO
TING ST
YLES
3
FILE BASED
4
PICTURE PR
OFI
LE
How to set/operate
The wireless microphone is connected in the same way as the
shotgun microphone. When using a two-channel system with
separate microphones, connect the left channel to INPUT1 and
the right channel to INPUT2.
For more information, refer to the manufacturer’s instructions
for the microphone.
TIPS
あああああああああああああああああああああああああああああああああああああああああああああああああああああああああああああああああ
あああああああああああああああああああああああああああああああああああああああああああああああああああああああああああああああああ
ああああああああああああああああああああああああああああああああああああああああああ。
TIPS
Adjusting the input level for external microphones
TRIM is used to adjust the microphone input level in accordance with the sound volume.
In the menu system, navigate to AUDIO SET → XLR SET → INPUT1(2) TRIM, then select the required trim value (-18 dB, -12
dB, -6 dB, 0 dB, +6 dB and +12 dB).
For high-sensitivity microphones, or when recording very loud sounds, reduce the trim value. For low sensitivity microphones,
increase the trim value.
Audio distortion may be caused by input distortion (at the microphone) or recording distortion (within the camera), or a
combination of both. To reduce input distortion, adjust the trim as described above. To reduce recording distortion, change
to manual audio mode (switches
③
and
⑦
) and adjust the input level dials (
④
and
⑧
) so that the sound level meters
remain out of the peak zone.
In certain settings the Audio Limiter can help to improve the sound quality when recording in manual audio mode. Use the
menu system to navigate to AUDIO SET → AUDIO LIMIT.
Wireless microphones are often used by reporters who are
constantly on the move. The microphone is connected to a
transmitter worn by the reporter. The receiver is attached to
the camera, providing an audio output feed that is connected
to the camera input.
Wireless and other external microphones
TIPS
A flat mono mix of CH1 and CH2 in the headphones can be used to check the balance between left and right channels while
recording. To switch to the mono mix, use the menu system to navigate to AUDIO SET → HEADPHONE OUT and select MONO.
The audio track can be monitored through headphones during
recording and playback, and also from the built-in speaker
during playback. The volume buttons and channel selector are
located on top of the camera at the back.
Adjusting the playback volume
Содержание NEX-EA50 NXCAM
Страница 1: ...NEX EA50 Handbook ...