Sony MVS-6000, Руководство пользователя

Страница: 127 / 400

127
Executing a Transition
Cha
pte
r 3
Sig
nal Se
lec
tion and
T
ra
ns
iti
ons
Executing a Transition With the Fader Lever (Manual
Transition)
Using the fader lever, you can manually control the progress of the transition.
Moving the fader lever from one end of its travel to the other completes the
transition.
To execute a manual transition with the transition control block fader lever, use
the following procedure.
To carry out the transition completely: Move the lever over the full range of
its travel.
To pause a partly executed transition: Stop moving the fader lever.
To resume a paused transition: Resume moving the fader lever.
Combinations of Auto and Manual Transitions
Using the [AUTO TRANS] button, the [CUT] button, and the fader lever, use
the following procedures.
Moving the fader lever during an auto transition
During an auto transition started by pressing the [AUTO TRANS] button,
operating the fader lever immediately enables the fader lever, and the [AUTO
TRANS] button goes off. Thereafter, the fader lever controls the progress of
the transition.
Executing an auto transition after partly moving the fader lever
• Press the [CUT] button to instantaneously complete the transition.
• Press the [AUTO TRANS] button to complete the rest of the transition at the
preset transition rate.
If the transition rate is set to 100 frames, and the fader lever has moved
through
1
/
4
of the transition, then the remaining
3
/
4
of the transition is carried
out in 100 frames.
Non-Sync State
If the fader lever is in an intermediate position when a transition is completed
as an auto transition, then the lever position no longer agrees with the transition
state. This is termed a non-sync state.