Sony MKS-6550, Руководство по установке

Страница: 5 / 38

1-1 (E)
MVS-6520
m
.
As the inrush current at turn-on is a maximum 100 A (at
100 V)/175 A (at 230 V), the capacity of the AC power
source must be commensurate with this load.
If the capacity of the AC power is not adequately large,
the AC power source breaker will operate or the unit will
abnormally operate.
.
The MVS-6520/6530/3000 contains two power supply
units as the standard configuration. When starting up the
MVS-6520/6530/3000, be sure to turn on the power of
two power supply units.
1-2-2. Power Cord
w
.
Use the approved Power Cord (3-core mains lead)/Appli-
ance Connector/Plug with earthing-contacts that con-
forms to the safety regulations of each country if appli-
cable.
.
Use the Power Cord (3-core mains lead)/Appliance
Connector/Plug conforming to the proper ratings (Volt-
age, Ampere).
If you have questions on the use of the above Power Cord/
Appliance Connector/Plug, please contact your local Sony
Sales Office/Service Center.
c
.
Never use an injured power cord.
.
Plugging the power cord in the AC inlet, push as far as it
will go.
Section 1
Installation
1-1. Operating Environment
Operating guaranteed temperature:
+
5
d
C to
+
40
d
C
Performance guaranteed temperature:
+
10
d
C to
+
35
d
C
Operating humidity (relative humidity): 10 % to 90 %
Storage temperature:
_
20
d
C to
+
60
d
C
Mass (when options are installed) :
MVS-6520: Approx. 20 kg
MVS-6530: Approx. 21 kg
MVS-3000: Approx. 19 kg
Prohibited locations for installation
.
Areas where the unit will be exposed do direct sunlight
or any other strong lights.
.
Dusty areas
.
Areas subject to vibration.
.
Areas with strong electric or magnetic fields.
.
Areas near heat sources.
.
Areas subject to electrical noise.
.
Areas subject where is subjected to static electricity.
Ventilation
In this unit, the air cooling is performed by using the fan
motor 120 square (for plug-in board) and fan motor (for
power unit).
(Refer to the air flow illustration of “Fan” in Section
2-2-2.)
The power supply can be damaged if the exhaust vent (both
sides) and air intake (front panel) are blocked or the fan is
stopped.
Therefore, leave a blank space of more than 10 cm in the
front and both sides of the MVS-6520/6530/3000.
1-2. Power Supply
1-2-1. Power Specifications
A switching regulator is used for the power supply of this
unit. The voltage within the range of 100 V to 240 V can be
used without changing the supply voltage.
Power requirements: AC 100 to 240 V
?
10 %
Power frequency: 50/60 Hz
Current consumption (when all options are installed) :
MVS-6520/6530/3000: 4.0 to 1.7 A
For customers in the U.S.A. and Canada
1 Power cord, 125 V 10 A (2.4 m) :
!
1-551-812-31
AC inlet
1
For customers in the all European countries
1 Power cord, 250 V 10 A (2.5 m) :
!
1-782-929-12
1
AC inlet