Sony MHC-V77W, Руководство по эксплуатации

Страница: 50 / 64

50
US
MHC-V77W.US.4-695-546- 12 (1)
Additional Information
Troubleshooting
Should you encounter a problem
with your system, find your problem
in the troubleshooting checklist
below and take the corrective
action.
If the problem persists, consult your
nearest Sony dealer.
Note that if the service personnel
changes some parts during repair,
these parts may be retained.
If “PROTECTX” (X is a number)
appears on the display
Immediately unplug the AC
power cord (mains lead), and
check if anything is blocking the
ventilation openings of the unit.
After you have checked and
found no problems, reconnect
the AC power cord (mains lead),
and turn on the system. If the
issue persists, contact your
nearest Sony dealer.
General
The power does not turn on.
•
•
Check that the AC power cord
(mains lead) is connected securely.
The system cannot be turned off
even though

is pressed.
•
•
You may have set the display
mode to the demonstration mode
unintentionally. Press DISPLAY
repeatedly to select Power Saving
Mode (page 20).
The system has entered standby
mode.
•
•
This is not a malfunction. The
system enters standby mode
automatically in about 15 minutes
when there is no operation or
audio signal output (page 47).
There is no sound.
•
•
Adjust the volume.
•
•
Check the connection of the
optional equipment, if any
(page 16).
•
•
Turn on the connected equipment.
•
•
Unplug the AC power cord (mains
lead), then plug in the AC power
cord (mains lead) again and turn
on the system.
There is no microphone sound.
•
•
Adjust the microphone volume
level.
•
•
Make sure the microphone is
connected to the MIC1 or MIC2 jack
on the unit correctly.
•
•
Make sure the microphone is
turned on.
There is severe hum or noise.
• •
Move the system away from
sources of noise.
•
•
Connect the system to a different
wall outlet.
• •
Install a noise filter (not supplied)
to the AC power cord (mains lead).
•
•
Turn off surrounding electrical
equipment.
• •
The noise generated by the
cooling fans of the system may be
heard when the system is turned
on. This is not a malfunction.
The remote control does not
function.
•
•
Remove the obstacles between
the remote control and the unit.
•
•
Move the remote control closer to
the unit.