![background image](http://html.mh-extra.com/html/sony/mex-xb120bt/mex-xb120bt_operating-instructions-manual_1329910038.webp)
38
GB
CODE ERROR
The entered passcode is incorrect.
– Enter the correct passcode.
– If you forget your passcode, perform
[SET SXM RESET] in [GENERAL] (page 23).
Note that performing [SXM RESET] will
initialize all the SiriusXM settings and
stored contents in the SiriusXM Connect
Vehicle Tuner.
NO SIGNAL
SiriusXM Connect Vehicle Tuner is having
difficulty receiving the SiriusXM satellite
signal.
– Verify that your vehicle is outdoors with
a clear view of the sky.
– Verify that the SiriusXM magnetic mount
antenna is mounted on a metal surface
on the outside of the vehicle.
– Move the SiriusXM antenna away from
any obstructions.
– Inspect the antenna cable for damage
and kinks.
– Consult the SiriusXM Connect Vehicle
Tuner installation manual for more
information on antenna installation.
– Replace the antenna if the cable is
damaged. SiriusXM products are
available at your local car audio retailer
or online at
www.shop.siriusxm.com
SUBSCRIPTION UPDATED - PRESS ENT TO
CONTINUE
The radio has detected a change in your
SiriusXM subscription status.
– Press ENTER to clear the message.
If you have questions about your
subscription, please contact SiriusXM.
In the USA, visit www.siriusxm.com or
call 1-866-635-2349.
In Canada, visit www.siriusxm.ca or
call 1-877-438-9677.
For steering wheel remote control
operation:
ERROR:
An error occurred during the
function registration.
Register again from the function where
the error occurred (page 22).
TIMEOUT:
The function registration failed
due to a timeout.
Try completing the registration while
[REGISTER] is blinking (about 6 seconds)
(page 22).
For firmware update operation:
ERROR:
The updater is not stored in the USB
device.
Store the updater in the USB device, then
try again (page 26).
NO DEVICE:
The USB device containing the
updater is not connected or recognized.
Make sure the USB device is securely
connected.
Disconnect the USB device, then connect
the device again.
UPDATE ERROR - PRESS ENTER:
Firmware
update is not completed properly.
Press ENTER to clear the message, then try
again.
During the update, do not turn the
ignition to the OFF position, nor remove
the USB device (page 26).
If these solutions do not help improve the
situation, consult your nearest Sony dealer.
If you take the unit to be repaired because of
CD playback trouble, bring the disc that was
used at the time the problem began.