22
GB
Recording on
an MD
This chapter explains how to record
onto an MD.
Notes on Recording
If “Protected” and “C11” appear in the display
The MD is record-protected. Close the record-protect slot
to enable recording (see “To protect an MD against
accidental erasure” on page 24).
If “Din Unlock” and “C71” appear in the display
• The digital program source selected with the INPUT
switch is not properly connected. Connect the program
source correctly.
• The program source is not turned on. Turn on the
program source.
Track numbers are marked differently depending
on the menu settings and the type of source
being recorded
• When recording from a CD or MD with this unit’s
INPUT switch set to “OPT” or “COAX”, track numbers
are automatically marked the same as the original
program source. However, in the following cases, a
section of a recording containing more than one track
may be marked with only a single track number:
– If the same track is recorded repeatedly (using the
single-track repeat function).
– If two or more tracks with the same track number
(from different MDs or CDs) are recorded in
sequence.
– When recording tracks less than four seconds long.
• Even though INPUT is set to “OPT” or “COAX”, this
unit may not be able to mark track numbers
automatically when recording from certain multi-disc
(and one-disc) CD players. In such cases, mark the track
numbers afterwards using the Divide Function (see
“Dividing a Track” on page 28).
• If the “L.Sync” parameter in the Setup Menu is set to
“L.Sync Off” when recording with INPUT set to
“ANLG”, or recording from a satellite broadcast or DAT
with INPUT set to “OPT” or “COAX”, this unit treats
the recorded section as a single track and only one track
number will be assigned to the recording.
• Set the “L.Sync” parameter in the Setup Menu to
“L.Sync On” when recording with INPUT set to
“ANLG”, or recording from a satellite broadcast or DAT
with INPUT set to “OPT” or “COAX”, to mark track
numbers automatically (see “Automatic track marking”
on page 24).
• When recording from a satellite broadcast or DAT with
INPUT set to “OPT” or “COAX”, this unit automatically
marks a new track number whenever the sampling
frequency of the input signal changes (regardless of the
setting of the “L.Sync” parameter in the Setup Menu).
