Quick Start Guide
Control and indication of the Recorder's modes are carried out using two hole-
buttons and three-color LED (between buttons)
on the front side of the device. For
pressing hole-buttons it is recommended to use fine wooden or plastic stick.
Colibri-SD may be used both as voice recorder to record audio files and as flash
card to store any other information.
Voice Recorder. Front view.
Opened Recorder. USB-charger.
1. RECORD button.
2. LED of Status Control.
3. STATUS Button.
4. Microphones
5. To open flash card chip push
down on the right edge of the
outlined rectangular area.
1. Slot for micro SD-card and
adaptor for charging.
2. Micro SD – USB adapter for
connecting to PC for charging.
3. Flash card chip
Charging and setting parameters
1. Charge the recorder’s battery using adaptor by connecting it to USB-port of any
PC. For that, if necessary remove SD-card and insert in this slot Micro SD – USB
adapter. Then connect Recorder with adapter to USB of the computer.
2. To initialize micro SD card insert it to the holder. Then, insert the holder with
micro SD to the PC, run the built-in program “
Kolibri_5
.exe”, perform
the
needed settings and click “WRITE CONFIGURATION”. In order to keep time
on
the recorder the same as on the PC, quickly insert SD card to the recorder
and press left hole-button (RECORD button).
3. The LED flashes red, then blue then turns off.
4. The recorder is initialized and ready to operate.
1
2
3
4
1
2
3
4
5
