– 12 –
* Remote commander display during automatic adjustment
4. If result of automatic adjustment is OK, the following display
appears.
5. If result of automatic adjustment is NG, the following display
appears.
* If NG, enter servo mode to perform automatic adjustment of the
item determined as NG.
057
Adjustment value (flashing)
Mode No. under adjustment
047
End-OK
051
NG
Error code
NG mode No.
Adjustment in Servo Mode Method
1. When each adjustment mode is set according to the structure of
servo mode, the lower two digits of the mode No. and the ad-
justment value written in EEPROM are displayed and lit on the
LCD on the remote commander.
2. When the
P
key is pressed, the following display appears and
the automatic adjustment is performed.
Note)
Although the /– keys can be used to change
the adjustment value to any value, they should not be
used whenever possible.
3. When the automatic adjustment is completed, the flashing ad-
justment value is lit.
052
Adjustment value (lit)
Mode No.
052
Adjustment value (flashing)
052
Adjustment value (lit)
