25
Installation
2
Input signals.
Setting Input Signals
1
Select the input signal you want to project on the screen from this
board using the “Input signal select drop-down list box” in the
SCREEN CONTROL window.
For details on how to select the desired setting from the SCREEN CONTROL window,
refer to the operating instructions for SRX-series projectors.
2
According to the input signal type, set “Signal Mode” on “Input
Source” in the PICTURE CONTROL window of the SRX
Controller.
INTER LOCK ETHERNET
RS232C
AUX
DVI-D
Left panel
To DVI-D connector
To AUX connector
DVI cable (not supplied)
To DVI output connector
Computer
