CH-SSTLU
Installation Instructions
6
9.
Use the 5/32" security hex key (W) to loosen rotational stop
adjustment screw until desired radius is achieved. (See
Figure 3) and (See Figure 5)
Figure 5
DISPLAY INSTALLATION
1.
Lay display face down on protective surface.
CAUTION:
Using screws of improper diameter may
damage your display! Proper screws will easily thread into
display mounting holes.
2.
Select screw
diameter
by examining hardware (N-S) (4mm,
5mm, 6mm, or 8mm) and comparing with mounting holes
on display. (See Figure 6)
3.
Select washers:
•
Refer to the Table 1-1 to determine which washers
(T or U) to use for display installation.
CAUTION:
Using screws of improper length may damage
your display! Proper screws will have adequate thread
engagement without contacting bottom of display mounting
holes.
4.
Select screw
length:
(for M4 screws only)
•
Using your hand, insert M4x12mm button head security
screw (N) through vertical interface bracket (C),
washers (T or U), into display mounting hole. Do NOT
thread screw into hole at this time.
•
Proper screw length requires base of screw head to
protrude above flat washer a
distance equal to or
greater than the screw diameter.
If screw length is
inadequate, use M4x16mm screw (P). Select
shortest
screw which will protrude the required distance.
5.
Place vertical interface brackets (C) on display, ensuring:
(See Figure 6)
•
Upper hooks are towards
top
of display.
•
Center of brackets (C) are as close to the center of the
back of display as possible after being installed. Center
of bracket is indicated by the diamond-shaped hole.
6.
Install selected screws through washers (T and/or U, if
required) vertical interface bracket (C) and into display
mounting holes. (See Figure 6)
rotational stop
adjustment screw
15°
30°
45°
90°
Rotation
(view from below)
radius
Table 1-1: Washer Usage
M4
M5
M6
#10 (T)
X
1/4" (U)
X
X
X
Figure 6
Vertical center
of display
Center of
bracket
(C) x 2
(T and/or U, if required)
3
(N-S) x 4, 6 or 8
6
5
Upper
hooks
