Installation Instructions
CH-SSTLU
5
ASSEMBLY TO DESK
1.
Use four 1/4-20 x 1/2" button head cap screws (H) to secure
table stand (A) to table stand interface (B). (See Figure 1)
NOTE:
If roll adjustment is desired, install screws through
rotational slots rather than the standard slots. (See
Figure 1)
NOTE:
In order to achieve a +/- 90° rotation radius while using
the rotational slots, the radius adjustment screw must
be removed and replaced with #10-24 x 1/2" socket
head cap screw (M). (See Figure 1)
Figure 1
2.
Determine mounting location by setting table stand on desk
and experimenting with desired rotation capabilities.
NOTE:
Rotation radius can be set at +/- 15°, 30°, 45°, or 90°.
See
Dimensions
drawing for details.
3.
Use clamping plate (D) as a template to mark locations for
the three holes to be drilled at desired mounting location.
4.
Drill three 5/16" holes at locations marked in Step 3. (See
Figure 2)
NOTE:
One hole should be centered at the front of the mount.
Figure 2
NOTE:
If cables will be routed through the table, an additional
hole needs to be drilled in center of clamping plate (D).
See
Cable Management
section for details.
5.
(Optional) If cables will be routed through the desk, drill an
additional hole in the center of the clamping plate that is
large enough to accommodate all cables that will be routed
through the desk. (See Figure 2)
Figure 3
6.
Lift lower cover on table stand to expose holes on lower
plate. (See Figure 3)
7.
Use three 1/4-20 x 2-1/2" hex head cap screws (G) and
three 3/16" washers (L) to secure table stand through
clamping plate (D) to desk. (See Figure 3)
IMPORTANT ! :
Provided screws (G) can be used to
install on surfaces up to 1-5/8" in depth. For deeper
tables, longer 1/4-20" screws (not provided) must be
used.
8.
Secure lower cover to table stand (A) using 10-24 x 1/2"
security screw (K). (See Figure 4)
Figure 4
NOTE:
Prior to installing display, the rotation radius should be
adjusted. Once the display is connected, it will no
longer be possible to adjust the rotational stop without
removing the display from the mount.
1
(A)
(B)
Rotational
Radius adjustment
screw
(H) x 4
slots
x 3
Front of mount
3
4
5
Lower cover
(G) x 3
6
(L) x 3
7
9
Desk
(D)
radius
adjustment
screw
Lower plate
(K)
8
(A)
