–
28
–
KV
-XA29K94/XA34K94
RM-962
•
REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and
the anode cap to the metal chassis, CRT shield or carbon paint on the
CRT.
•
REMOVING PROCEDURES
1
Do not damage the surface of anode-caps with sharp shaped objects.
2
Do not press the rubber too hard so as not to damage the inside of anode-cap.
A metal fitting called the shatter-hook terminal is built into the rubber.
3
Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the rubber.
•
HOW TO HANDLE AN ANODE-CAP
3
When one side of the rubber cap is separated from the anode button, the anode-cap
can be removed by turning up the rubber cap and pulling it up in the direction of the
arrow
c
.
2
Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow
b
.
1
Turn up one side of the rubber cap in the direction indicated by the arrow
a
.
a
a
b
b
c
Anode Button
2-13. PICTURE TUBE REMOVAL
NOTE : i)
Please remove necessary CRT support located on top left, top right,
bottom left, bottom right, prior to removing the CRT.
ii)
9
and
q/
(screws Tapping 7+ Crown Washer)
(KV-XA29K94).
iii) Nut, Special, CRT and cap screw (KV-XA34K94 only).
6
Two screws
wf
Cap, screw
wf
Cap,
screw
(+BVTP 4
×
16)
qh
C6 board
qg
Neck assy
qj
Degaussing coil
Degaussing coil
qk
Four claws
DGC clips
(KV-XA29")
DGC clips
qa
Chassis assy
wa
Four DGC clips
8
Two screws
(+P 4
×
16)
(washer head)
q;
Two screws
Crown Washer)
(Tapping 7+
4
Two screws
(+P 4
×
16)
(washer head)
9
Two screws
Crown Washer)
(Tapping 7+
ws
Holder DGC
w;
Cushion (50x550) DGC
Cushion (S) DGC
Cushion (S) DGC
w;
Cushion (50x550) DGC
2
Two screws
(+BVTP 4
×
16)
1
Speaker
(5cm)
qf
Deflection
yoke
qd
Tension
spring
ql
DGC
DGC band
DGC Holder
band
qs
Anode cap
qg
Picture tube
qf
Cushion
5
Speaker
wd
Nut,
Special
CRT
wd
Nut,
Special
CRT
(5cm)
7
Speaker
(15
×
6.5cm)
3
Speaker
(15
×
6.5cm)
CRT (Top,right)
Support Assy
CRT (Top,left)
Support Assy
Two screws
(+BVTP 4
×
16)
Two screws
(+BVTP 4
×
16)
(KV-XA34")