Sony KP-41T35 - 41" Projection Tv, Руководство по эксплуатации

Страница: 36 / 84

36
-EN
Operations
1 2 3
4 5 6
7 8
0
9
Operating a VCR
To turn on or off
To select a channel
directly
To change channels
To record
To play
To stop
To fast forward
To rewind the tape
To pause
To search the picture
forward or backward
To change input mode
Operating video equipment
Use the video operating buttons on the remote
control to operate the video equipment.
Press VTR (FUNCTION) before operating the
video equipment.
VTR (POWER)
ENTER
0 – 9 buttons
CH +/–
VTR (FUNCTION)
Video operating
buttons
Buttons on the remote control
Press VTR (POWER).
Press the 0 – 9 buttons.
Press CH +/–.
Press
( while pressing r . First release
( , then release r .
Press ( .
Press p .
Press ) .
Press 0 .
Press P .
To resume normal playback, press again.
Press
) or 0 during playback.
To resume normal playback, release the
button.
Press TV/VTR.
Buttons on the remote control
Press VTR (POWER).
Press
( .
Press p .
Press
P
.
To resume normal playback, press again.
Keep pressing
)
or
0
during
playback.
To resume normal playback, release the
button.
Press CH +/–.
Operating an MDP
To turn on or off
To play
To stop
To pause
To search the picture
forward or backward
To search the chapter
forward and backward
Note
• If the video equipment does not have a certain function, the
corresponding button on this remote control will not operate.
MDP manufacturer code numbers
Manufacturer Code number
Sony 701
Kenwood 707
Magnavox 703
Maranz 702
Mitsubishi 702
Panasonic 704
Philips 703
Pioneer 702
RCA 702
Sanyo 706
Sharp 705
Yamaha 703
Notes
• If more than one code number is listed, try entering them one
by one, until you come to the correct code for your equipment.
• In some rare cases, you may not be able to operate your non-
Sony video equipment with the supplied remote control. This
is because your equipment may use a code that is not included
with this remote control. In this case, please use the
equipment’s own remote control unit.
• The code numbers for Sony equipment are assigned at the
factory as follows:
VHS VCR
301 (preset code for the supplied
remote control)
8 mm VCR 302
Beta, ED Beta VCRs 303
• Whenever you remove the batteries — to replace them, for
example — if too much time is taken, the code number may
revert to the factory setting and must be reset.