Sony ILME-FX6T, Руководство по обслуживанию

Страница: 103 / 178

100
2-12-2. SDI-1004 Board
Note
The following parts are not reusable. Prepare new parts in advance.
• Tape AS: 1 pc
Preparation
1. Remove the top cabinet and the bottom cover. (Refer to “2-2. Top Cabinet, Bottom Cover”.)
2. Remove the inside panel. (Refer to “2-3. Inside Panel”.)
3. Remove the outside panel. (Refer to “2-4. Outside Panel”.)
4. Remove the VC-1046 board. (Refer to “2-5. VC-1046 Board”.)
5. Remove the CK-1027 board. (Refer to “2-8. CK-1027 Board”.)
6. Remove the VF-1024 board. (Refer to “2-10. VF-1024 Board”.)
Procedure
1. Disconnect the fine-wire coaxial cable from the connector (CN6001) on the SDI-1004 board.
2. Peel off the tape AS from the SDI shield case.
Note
The tape AS is not reusable.
Note
• Align the mountain fold portion of the flexible flat cable with the edge of the shield case.
• Attach a new tape AS at the position as shown in the figure.
CN6001
SDI shield case
SDI-1004 board
Fine-wire coaxial cable
Tape AS
Tape AS
Shield case
Mountain fold
Attaching position of the Tape AS and
arrangement of flexible flat cable