Sony HT-SF370, Руководство по эксплуатации

Страница: 27 / 76

27 US
Getting Star
ted
The table below shows the display when
measurement starts.
Notes
• If “CHECK MIC” appears, you cannot perform
the Auto Calibration. Connect the optimizer
microphone, then perform the Auto Calibration
again.
• If “PHONES” appears, you cannot perform the
Auto Calibration. Disconnect the headphones
from the S-AIR product you are using, then
perform the Auto Calibration again.
Tips
• When Auto Calibration starts:
– Stand some distance from the speakers and the
listening position to avoid measurement failure.
This is because test signals are output from the
speakers during measurement.
– Avoid making noise to get a more accurate
measurement.
• The Auto Calibration function will be canceled
when you do the following during the
measurement process:
– Press
?
/
1
or MUTING.
– Press input buttons on the remote or INPUT
SE/– on the receiver.
– Change the volume level.
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
2
Press V / v repeatedly to select
the item, then press .
Note
After “SAVE EXIT” is displayed for 50
seconds, the measurement result is saved
automatically, without the need to save the
procedure.
3
Save the measurement result.
Select “SAVE EXIT” in step 2.
The measurement results are saved.
Measurement for Display
Speaker existance TONE
Speaker gain, distance,
frequency response T. S. P.
Subwoofer gain and
distance SUBWOOFER
Confirming/saving the
measurement results
Measurement
result Display Explanation
When the
measurement
process
completes
properly SAVE
EXIT Proceed to step
2.
When the
measurement
process fails ERROR
XXXX
See “When
error codes
appear” (page
28).
Item Explanation
SAVE EXIT Saves the measurement
results and exits the setting
process.
WRN CHECK Displays warning
concerning the
measurement results. See
“When you select “WRN
CHECK”” (page 28).
DIST INFO Displays the measurement
result for speaker distance.
LEVEL INFO Displays the measurement
result for speaker level.
EXIT Exits the setting process
without saving the
measurement results.
continued