Sony HT-IV300, Руководство по эксплуатации

Страница: 49 / 68

49
GB
Ot
h
e
r f
unc
tions
8
Press V / v to select [Test Tone], then
press .
9
Press V / v to select [Off], then press
.
• The test tone signals are not output from the
HDMI (OUT) jack.
• The test tone will not output from the center
speaker if [Centre Speaker] is set to [Off].
To adjust the volume of all the speakers at the
same time, press
2
+/–.
Using the Sleep Timer
You can set the system to turn off at a
preset time, so you can fall asleep listening
to music.
Press SLEEP.
Each time you press SLEEP, the minutes
display (the remaining time) in the front
panel display changes by 10 minutes.
When you set the sleep timer, the
remaining time appears every 5 minutes.
When the remaining time is less than
2 minutes, “SLEEP” flashes in the front
panel display.
To check the remaining
time
Press SLEEP once.
To change the remaining
time
Press SLEEP repeatedly.
Changing the
Brightness
You can change the brightness of the front
panel display and the LED indicator.
Press DIMMER
Each time you press the button, the
brightness of the item is changed. You can
adjust the brightness in 3 levels,
[Dimmer : 1], [Dimmer : 2] and
[Dimmer : 3].
• For front panel display, the brightness for all 3
levels are the same. However, in [Dimmer : 3]:
– front panel display and LED indicator will
light off if any button on the main unit or
remote control is not pressed within 10
seconds.
– front panel display and LED indicator will
light on for a few seconds if any button on the
main unit or remote control is pressed.
• Depending on the situation, the front panel and
LED indicator may remain light on in
[Dimmer : 3].
Saving Power in
Standby Mode
Check that you have made the following
settings:
– [Control for HDMI] in [HDMI Settings]
is set to [Off] (page 53).
– [Quick Start Mode] is set to [Off]
(page 53).
– [Remote Start] is set to [Off] (page 54).
– [NFC] is set to [Off] (page 53).
Notes
Tip
Notes