20
US
Before connecting the AC power cord (mains
lead) of the receiver and the subwoofer to a wall
outlet (mains), connect all the other equipment
and TV to the system.
• After connecting the AC power cord (mains lead),
wait about 20 seconds before turning on the power by
pressing
?/1
on the receiver.
• Connect the system to an easily accessible AC outlet
(mains). Should you notice an abnormality in the
system, disconnect the main plug from the AC outlet
(mains) immediately.
The receiver transmits sound from the equipment
to the subwoofer. To activate wireless
transmission, perform the following Steps.
1
Check that the wireless transceivers
(supplied) are inserted into the wireless
transceiver (EZW-RT50/EZW-RT20) slot
on the rear panel of both the receiver
and the subwoofer.
For details, see “Installing the supplied
wireless transceivers” (page 15).
2
Press
?/1
to turn the receiver on.
When wireless transmission is activated, the
LINK/STANDBY indicator turns green.
If the LINK/STANDBY indicator does not
turn on, see “Subwoofer” (page 10) and
“Wireless sound” (page 42).
About the standby mode
The subwoofer enters standby mode
automatically (the LINK/STANDBY indicator
turns red) when the receiver is in standby mode
or wireless transmission is not activated.
The subwoofer turns on automatically (the
LINK/STANDBY indicator turns green) when
the receiver is turned on and wireless
transmission is activated.
To specify a wireless connection
If you use multiple wireless products, you can
prevent interference by specifying the wireless
connection to be used to link the receiver to the
subwoofer (Secure Link function).
For details, see “Activating wireless
transmission between specific units (SECURE
ON)” (page 39).
By connecting Sony equipment compatible with
“BRAVIA” Sync via an HDMI cable (not
supplied), you can operate other equipment
using only one remote control.
To use “BRAVIA” Sync, set the Control for
HDMI function to on for the connected
equipment.
When you use a Sony TV which has a Control
for HDMI function, setting the Control for
HDMI function on TV will set the Control for
HDMI function of the system and other
connected equipment simultaneously.
1
Make sure that the system is connected
to the TV and the connected equipment
via HDMI cables (not supplied).
Connecting the AC power
cord (mains lead)
Notes
Setting up the Wireless
System
Preparing for “BRAVIA”
Sync
?/1
AMP
MENU
C
,
X
,
x
,
c
,
Input
buttons
