Sony HT-CT180, Руководство по обслуживанию

Страница: 11 / 36

HT-CT180
11
2-6. NFC MODULE
2-7. LED BOARD
Note 2: Please spread a sheet
under a unit not to
injure front cabinet.
Note 3: When installing the NFC module
to the NFC bracket, install so that
the solder portion of the wire is
positioned as shown in the figure
below.
– Front cabinet block rear top view –
solder portion
NFC module
NFC bracket
– NFC module block bottom view –
5 NFC module
1 connector
(XP12)
4
NFC bracket
2 screw
(3
u
8 S)
3 Peel off the adhesive sheet.
‡+RZWRLQVWDOOWKH1)&PRGXOH
Top side
Left side
Bottom side
colored line
Insert straight into the interior.
flexible flat
cable
connector
OK
colored line
Insert at a slant.
flexible flat
cable
connector
NG
‡ How to install the flexible flat cable
When installing the flexible flat cable,
ensure that the colored line is parallel
to the connector after insertion.
– Front cabinet block rear bottom view –
Note: Please spread a sheet under a unit
not to injure front cabinet.
2
two screws
(3
u
8 S)
terminal side
3
LED board
1
FFC 10P (FFC1)
(XP5)
Right side
Left side
Bottom side
Note 1: When replacing the BT NFC board or the NFC module, be sure to
replace both at the same time.
The BT NFC board or the NFC module cannot replace with single.