1-5 (E)
HDW-1800/D1800
.
Attaching the rack angles (handles)
8.
Remove the four screws from both sides (left and
right) of the unit.
n
Keep these screws (B4
x
6).
Be sure to use these screws when directly fixing the
side panels without the rack angles.
The use of longer screws such as the screws (PSW 4
x
16) for fixing the rack angles of RMM-130 will cause
a malfunction of the unit.
9.
Attach the two rack angles to both sides (left and right)
of the unit with the four screws (PSW4
x
16).
Tightening torque: 120
x
10
_
2
N
.
m {12.2 kgf
.
cm}
n
.
For RMM-131, screws with stop washers are used
for fixing the rack angles.
.
For RMM-130, use the supplied screws PSW4
x
16
as shown in Fig. 1.
.
Attaching the inner rails
4.
Pull out the inner rails from the two intermediate rails.
5.
While pressing the stopper of the inner rail in the
direction of the arrow A in the figure, pull the inner
rail out in the direction of the arrow B.
6.
Remove the ten screws from both sides (left and right)
of the unit as shown in the figure below.
7.
Attach the two inner rails to both sides (left and right)
of unit with the removed screws in the step 6.
Tightening torque: 120
x
10
_
2
N
.
m {12.2 kgf
.
cm}
m
.
Be sure to use the (B4
x
6) screws when attaching
the inner rail. The use other-sized screws may cause
a malfunction.
.
Pay attention not to fasten the screws to the screw
holes other than actually used screw holes for fixing
the inner rails on both sides of the unit.
If unnecessary screws are fastened, rack mounting
will be unenabled.
n
When replacing a 5U size Sony VTR with this unit, attach
the inner rails to the low position, so that the bottom of the
unit becomes same as that of the 5U size VTR.
A
B
Outer rail
Intermediate rail
Inner rail
Stopper
B4
x
6
B4
x
6
Inner rail
Inner rail
B4
x
6
B4
x
6
B4
x
6
PSW4
x
16
PSW
4
x
16
Rack angle
Rack angle
Rack angle
Fig.1 For RMM-130 (Left side)