111
Qu
ick
Re
fe
re
nc
e
Remote Commander
A
DATA CODE button (72)
Displays the date and time or camera setting
data of the recorded images when you press this
during playback.
B
PHOTO button (30)
The on-screen image when you press this
button will be recorded as a still image.
C
SCAN/SLOW buttons (36)
D
.
>
(Previous/Next) buttons (36)
E
PLAY button (36)
F
STOP button (36)
G
DISPLAY button (17)
H
Transmitter
I
START/STOP button (30)
J
K
PAUSE buttons (36)
L
VISUAL INDEX button (35)
Displays a VISUAL INDEX screen during
playback.
M
b
/
B
/
v
/
V
/ ENTER buttons
When you press any button on the [VISUAL
INDEX]/[Film Roll Index]/[Face Index]/
Playlist screen, the orange frame appears on the
LCD screen. Select a desired button or an item
with
b
/
B
/
v
/
V
, then press ENTER to enter.
b
Notes
• Remove the insulation sheet before using the
Remote Commander.
• Point the Remote Commander towards the remote
sensor to operate your camcorder (p. 108).
• When no commands have been sent from the
Remote Commander within a certain period, the
orange frame disappears. When you press any of
b
/
B
/
v
/
V
, or ENTER again, the frame appears
at the position where it was displayed last.
• You cannot select some buttons on the LCD
screen using
b
/
B
/
v
/
V
.
To change the battery of the Remote
Commander
1
While pressing on the tab, inset your
fingernail into the slit to pull out the battery
case.
2
Place a new battery with the + side facing
up.
3
Insert the battery case back into the Remote
Commander until it clicks.
• When the lithium battery becomes weak, the
operating distance of the Remote Commander
may shorten, or the Remote Commander may
not function properly. In this case, replace the
battery with a Sony CR2025 lithium battery.
Use of another battery may present a risk of fire
or explosion.
WARNING
Battery may explode if mistreated. Do not
recharge, disassemble or dispose of in
fire.
Insulation sheet
Tab
