– 11 –
AMS Test Mode
• This mode is used for checking the AMS operations of the tape deck.
JIG
7-819-039-12 Alignment tape, AMS-110A
Procedure:
1. Press the
1
/
u
button to turn the unit ON.
2. Set the tape (AMS-110A).
3. Press the three buttons
p
, ENTER/NEXT , and DISC 3 button simultaneously.
4. “TEST MODE” is displayed on the fluorescent display tube.
5. Press the FUNCTION button and switch the function to the deck with the tape (AMS-110A).
6. Press the CD SYNC button. “AMS CHECK” is displayed on the fluorescent display tube and the tape is rewound.
7. AMS starts in the normal direction. If the AMS count is 2 at shut down, proceed to step 8.
“NG” is displayed at other times, and the deck stops.
8. AMS starts in the opposite direction. If the AMS count is 2 at shut down again, “OK” is displayed.
“NG” is displayed at other times.
Note: The
p
button of CD section will become effective and the aging of CD section will stop sometime, if the buttons described in step 3
are not pressed simultaneously. In that case, press
^
button and operate the CD section.
Содержание HCD-VX8
Страница 6: ... 6 This section is extracted from instruction manual ...
Страница 26: ...HCD VX8 VX8J 8 3 PRINTED WIRING BOARD CD SECTION See page 18 for Circuit Boards Location 33 34 Page 42 ...
Страница 28: ...HCD VX8 VX8J 8 5 SCHEMATIC DIAGRAM DECK SECTION 37 38 Page 55 ...
Страница 46: ...HCD VX8 VX8J 8 24 SCHEMATIC DIAGRAM TRANS SECTION 73 74 Page 54 Page 57 ...