– 5 –
POSITIONS FOR SERVICING THE CONNECTOR
BOARD, SUB-TRANS BOARD, CHEMI-CON BOARD,
AND AMP BOARD
1
Remove the four screws securing the upper cover, and remove
the upper cover.
2
Remove the loading panel. (Refer to SECTION 3 DISASSEM-
BLY.)
3
Remove the four screws
A
securing the MAIN board, five screws
B
securing the rear panel, two flat cables (CN701, CN702),
and open the MAIN board as shown in the figure.
4
Remove the two screws
C
securing the heat sink, and remove
the AMP board and CHEMI-CON board.
5
Remove the two screws
D
securing the SUB-TRANS board
and four screws
E
securing the CONNECTOR board, and re-
move the SUB-TRANS board and CONNECTOR board.
6
Return the MAIN board to its original position.
7
Insulate these boards and the MAIN board with paper, etc., and
assemble the CONNECTOR board, SUB-TRANS board,
CHEMI-CON board, and AMP board on these boards.
Should be insulatable
with paper, etc.
A
A
C
D
B
B
E
Heat sink
SUB-TRANS board
AMP board
CHEMI-CON board
CONNECTOR board
MAIN board
Flat type wire (CN701)
Flat type wire (CN702)
Содержание HCD-SD1
Страница 27: ...HCD SD1 35 36 7 10 SCHEMATIC DIAGRAM PANEL SECTION Page 30 Page 30 ...
Страница 29: ...HCD SD1 7 12 SCHEMATIC DIAGRAM AMP SECTION 39 40 Page 47 48 Page 43 Page 28 ...
Страница 31: ...HCD SD1 7 14 SCHEMATIC DIAGRAM CONNECTOR SECTION 43 44 Page 30 Page 29 Page 40 Page 33 ...
Страница 33: ...HCD SD1 7 16 SCHEMATIC DIAGRAM REG SECTION 47 48 Page 40 Page 29 Page 29 Page 33 ...