9
SECTION 3
SERVICE MODE
[Panel Test Mode]
Procedure:
1. Set to standby state.
2. Press three buttons of
s
,
?/1
, and
7
simultaneously.
3. Liquid crystal display and LED are all turned on.
4. Pless
Z
to enter the version display mode.
5. Press
7
to enter the KEY, VOL, check mode. (
l j
and
J
L
must be pressed for several seconds.)
6. To exit from this mode, press the buttons in the same way as
step 2.
[Aging Mode]
This mode can be used for operation check of CD section.
Procedure:
1. Load a CD disc.
2. Set to standby state.
3. Press three buttons of
s
, DISPLAY , and
7
simultaneously.
4. The aging is executed in bellow sequence.
5. To exit from the aging mode, press the
?/1
button to turn the
power OFF.
[Cold Reset]
Clears all the memories and starts up the machine again.
Procedure:
1. Set to standby state.
2. Press three buttons of
s
,
?/1
, and FUNCTION
simultaneously.
[Hot Reset]
Starts up the machine again holding the memory data.
Procedure:
1. Set to standby state.
2. Press three buttons of
s
,
?/1
, and FUNCTION
simultaneously.
Содержание HCD-RB5
Страница 13: ...HCD RB5 13 13 5 4 SCHEMATIC DIAGRAM BD SECTION See page 11 for Waveforms See page 22 for IC Block Diagrams ...
Страница 16: ...HCD RB5 16 16 5 7 SCHEMATIC DIAGRAM MAIN SECTION 2 2 See page 22 for IC Block Diagrams ...
Страница 19: ...HCD RB5 19 19 5 10 SCHEMATIC DIAGRAM PANEL SECTION ...
