Sony HCD-PZ1D, Руководство по обслуживанию

Страница: 20 / 108

HCD-PZ1D
20
2-19. BU HOLDER BLOCK
– Bottom side view –
qs
floating screw
(PTPWH M2.6)
qa
dust cover (BU)
qd
shaft
qf
cam shaft
8
two screws
(BVTP 3
u
8)
9
screw
(BVTP 2.6 (3CR))
4
wire (flat type) (9 core)
(CN1106)
3
flexible flat cable (7 core)
(CN1104)
6
wire (flat type)
(7 core)
(CN4602)
1
connector
(CN1105)
2
connector
(CN1103)
5
connector
(CN601)
7
connector
(CN201)
‡ : i U e setti QJ
CN101
Tape
Note 2: Process the wire
straight so as not
to touch on the
connector.
NG
Tape
Tape
Tape
Tape
0
Perform work with this wire (flat type) (24 core) connected, or make a bridge as mentioned above and then disconnect
the wire (flat type) (24 core). (Optical pick-up will be destroyed without bridging.)
On the contrary at the installation, connect the wire (flat type) (24 core) first, and then remove the bridge.
Note 1: For a soldering iron, use the one with a ground wire. (Refer to DISASSEMBLY 2-19. DMB19 BOARD)
‡ 35(&$87,2 N :+( N 5(029, NG :,5( )/$7 7<3( &25(
qg
BU holder block
Note 4: When you disassemble the BU holder block,
confirm the holder (310) assy is a normal
position.
holder (310) assy lever (lifter (H)) holder (310) assy Note 5: When you install the BU holder
block, hang the holder (310) assy
on the lever (lifter (H)).
OK NG
lever (lifter (H))
Note 3: When you install the flat cable, please
install them correctly.
There is a possibility that this machine
damages when not correctly installing it.
Insert is straight
to the interior.
connector
Insert is incline
flexible
cable
connector
flexible
cable
OK NG