20
MAGNET ASSY ALIGNMENT
1. Check that there is no disc in the unit and then turn ON the power. Open the door, and set a disc in the PLUS ONE slit.
2. Close the door, and while pressing the
x
button, ENTER button and CLOCK/TIMER SET button simultaneously.
3. Press the CHECK button, and set the loading mode.
4. Press the +
J
L
button and chuck the disc.
5. Adjust the magnet assembly and magnet holder so that A = B as shown in the figure.
DISC HOLDER A ALIGNMENT
1. Check that there is no disc in the unit and then turn ON the power. Open the door, and set a disc in the PLUS ONE slit.
2. Close the door, and while pressing the
x
button, ENTER button and CLOCK/TIMER SET button simultaneously.
3. Press the CHECK button, and set the loading mode.
4. Press the +
J
L
button and chuck the disc.
5. Press +
J
L
or
l
j
– button to stop the disc holder A slightly away from the disc.
6. Rotate and adjust the adjusting screw so that the center of the disc and that of the disc holder coincide.
A B
Magnet ASSY
Magnet holder
Magnet ASSY
Screw (For adjustment)
Disc
Disc holder A
Disc holder A
Screw (For adjustment)
Disc
a = b
a b
Содержание HCD-M100
