Sony HCD-LF1H, Руководство по обслуживанию, Страница: 24 / 82

24
HCD-LF1H
DVD SECTION
8. Mirror Time Check
[TEST DISC LIST]
Be sure to use the DVD disc that matches the signal standards of
your region.
HLX-513 (Part No.: J-2501-305-A)
HLX-A1
(Part No.: J-2501-307-A)
8-1. GENERAL DESCRIPTION
The Mirror Time allows you to make diagnosis and adjustment
simply by using the remote commander and monitor TV. The
instructions, diagnosis results, etc. are given on the on-screen display
(OSD).
Be sure to execute the Mirror time when a BU (Base Unit) is
replaced.
8-2. HOW TO ENTER TEST MODE
Press three buttons x ,
A
and simultaneously with
the DVD player.
The Test Mode starts, then the menu shown below will be displayed
on the TV screen.
The menu above is the Remocon Diagnosis Menu screen which
consists of five main functions. At the bottom of the menu screen,
the model name and IF-con version. To enter Mirror Time
Adjustment menu, press button 2 “R” on the remote commander
to enter Drive Manual Operation menu. To exit from the Test Mode,
press the power button on the remote commander.
8-3. DRIVE MANUAL OPERATION
The Drive Manual Operation menu consists of five main functions.
By pressing 2 “R” button on the remote commander in the Remocon
Diagnosis Menu, the screen will appear as shown.
Remocon Diagnosis Menu
0. External Chip Check
1. Servo Parameter Check
2. Drive Manual Operation
3. Emergency History
4. Version Information
Model Name : LFZ5_ XX
IF-con
: V
Syscon : Ver.
er. XX.XX (XXXX)
X.XXX
* 1
*1: Changes depending on destination
Drive Manual Operation
1. Servo Control
2. Track/Layer Jump
3. Manual Adjustment
4. Tray Aging Mode
5. MIRR time Adjust
0. Return to Top Menu
8-4. MIRROR TIME ADJUSTMENT
To enter Mirror Time Adjustment, press 5 “R” button on the remote
commander. The screen will appear as shown.
There are five main commands in the MIRR time Adjust menu as
shown in the figure above. The functions of each command are
described in the following page.
1. CD MIRR time Check
This command checks the Mirror time value for CD disc.
2. DVD MIRR time Check
This command checks the Mirror time value for DVD disc.
3. Threshold
This command displays the threshold value between CD and DVD
mirror time.
4. Save to EEPROM
This command saves an adjusted mirror time value to the EEPROM.
5. Default set MIRR time
This command will set CD and DVD mirror time to firmware default
value.
[Open] / [Close]
Pressing the
A
button controls the tray for disc change during
mirror time adjustment.
[0] Return to previous menu
Press the 0 “R” button to return to previous menu.
8-4-1. EXECUTING MIRROR TIME ADJUSTMENT
In order to execute mirror time adjustment, the following standard
procedures must be followed.
(1) Press three buttons
x
,
A
and
simultaneously.
MIRR time Adjust Menu
1. CD MIRR time Check:
2. DVD MIRR time Check:
3. Threshold:
4. Save to EEPROM
5. Default set MIRR time
[Open] Tray open [Close] Tray close
[0] Return to previous menu
Remocon Diagnosis Menu
0. External Chip Check
1. Servo Parameter Check
2. Drive Manual Operation
3. Emergency History
4. Version information
Model Name :
IF-con
: Ver. XX.XX (XXXX)
Syscon : Ver. X.XXX
: LFZ5_ XX
* 1
*1: Changes depending on destination