![background image](http://html.mh-extra.com/html/sony/hcd-gsx75-system-components/hcd-gsx75-system-components_service-manual_420742018.webp)
18
HCD-GSX75
SECTION 5
MECHANICAL ADJUSTMENTS
•
TAPE MECHANISM DECK SECTION
Precaution
1. Clean the following parts with a denatured alcohol-moistened
swab:
record/playback heads
pinch rollers
erase head
rubber belts
capstan
idlers
2. Demagnetize the record/playback head with a head demagne-
tizer.
3. Do not use a magnetized screwdriver for the adjustments.
4. After the adjustments, apply suitable locking compound to the
parts adjusted.
5. The adjustments should be performed with the rated power
supply voltage unless otherwise noted.
SECTION 6
ELECTRICAL ADJUSTMENTS
Precaution
1. Demagnetize the record/playback head with a head demagne-
tizer.
2. Do not use a magnetized screwdriver for the adjustments.
3. After the adjustments, apply suitable locking compound to the
parts adjust.
4. The adjustments should be performed with the rated power
supply voltage unless otherwise noted.
5. The adjustments should be performed in the order given in
this service manual. (As a general rule, playback circuit ad-
justment should be completed before performing recording
circuit adjustment.)
6. The adjustments should be performed for both L-CH and R-
CH.
7. Switches and controls should be set as follows unless other-
wise specified.
• Test Tape
Tape
Signal
Used for
P-4-A100
10 kHz, – 10 dB
Azimuth Adjustment
WS-48B
3 kHz, 0 dB
Tape Speed Check
0 dB = 0.775 V
DECK SECTION
Torque Measurement
2.44 mN • m to 8.33 mN • m
30 to 85 g • cm
(0.42 – 1.17 oz • inch)
0.14 mN • m to 0.59 mN • m
2 to 6 g • cm
(0.03 – 0.08 oz • inch)
2.94 mN • m to 7.84 mN • m
31 to 71 g • cm
(0.43 – 0.98 oz • inch)
6.86 mN • m to 20.6 mN • m
71 to 210 g • cm
(0.98 – 2.91 oz • inch)
Mode
Torque meter
CQ-102C
CQ-102C
CQ-102RC
CQ-201B
Meter reading
FWD
FWD /REV
back tension
REV
FF/REW