![background image](http://html.mh-extra.com/html/sony/hcd-gs200/hcd-gs200_service-manual_420740022.webp)
22
HCD-GS200
E-F Balance Check
Connection:
Procedure:
1.
Connect an oscilloscpe to test point TP (TE1) and TP (DVC)
on the CD board.
2.
Turn the power on.
3.
Select the function “CD”.
4.
Press three buttons of
[ENTER]
,
M
, and
[TIMER SELECT]
simultaneously to set the CD service mode.
5.
Put the disc (YEDS-18) in to playback the number five track.
6.
Press the
.
button. The message “TRAVERSE” is
displayed. (The tracking servo and the sledding servo are turned
OFF)
7.
Check the level B of the oscilliscope's waveform and the A
(DC voltage) of the center of the Traverse waveform.
Confirm the following :
A/B x 100 = less than
±
22%
Traverse Waveform
8.
Press the
.
button. The message “TRAVERSE” is
displayed. (The tracking servo and sledding servo are turned
ON)
Confirm the C (DC voltage) is almost equal to the A (DC
voltage) is step 5.
9. To exit from this mode, perform as follows.
1) Move the optical pick-up to the most inside track.
2) Press three buttons of
x
,
[CLEAR]
, and
[DISPLAY]
simultaneously. (cold reset)
• Always move the optical pick-up to most inside track when
exiting from this mode. Otherwise, a disc will not be unloaded.
• Do not run the sled motor excessively, otherwise the gear can
Checking Location: CD board (Conductor side)
+
–
CD board
TP (TE1)
TP (DVC)
oscilloscope
Checking Location:
– CD BOARD (Conductor Side) –
TP (FE1)
IC104
IC101
IC103
TP (TE1)
TP (RFAC)
TP (DVC)
0V
B
level: 1.15
±
0.5 Vp-p
Center of
the waveform
A (DC
voltage)
Tracking servo
Sled servo
ON
C (DC
voltage)
Tracking servo
Sled servo
OFF
www. xiaoyu163. com
QQ 376315150
9
9
2
8
9
4
2
9
8
TEL 13942296513
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299