Airpeak gimbal setting guide
I
Manual adjustment of motor parameters
10
3
ROLL axis parameter adjustment.
In the same sequence as TILT axis adjustment,
tune the parameter in ROLL axis.
While holding the gimbal so that it doesn’t
move in PAN axis, push the left side of the
gimbal’s ROLL axis down with your hand
until it reaches ±10 degrees.
Increase the ROLL value in BASIC setting until
the overshoot is eliminated. Search for the
minimum value, as gimbal oscillation will
occur when the value is too high.
4
PAN axis parameter adjustment.
In the same sequence as TILT axis adjustment,
tune the parameter in PAN axis.
While holding the aircraft so that it doesn’t
move, push the gimbal in PAN axis until it
reaches ±10 degrees.
Increase the PAN value in BASIC setting until
the overshoot is eliminated. Search for the
minimum value, as gimbal oscillation will
occur when the value is too high.
(-10)
(+10)
(+10)
(-10)
Hint: PAN value in the BASIC setting screen
would change because the gimbal is not
connected to the aircraft and the gimbal can
move in PAN axis.
If this phenomenon occurs, press the POWER
button near the upper left of the screen to turn
the gimbal off. After a few seconds, press this
POWER button again then the gimbal turns on
with initial (0 degree) position.
4. Adjust motor parameters on each axis
(continued)
