Sony FD Trinitron KV-29LS30K, Руководство по обслуживанию

Страница: 20 / 49

20
Sub Colour Adjustment
1. Receive a PAL colour bar signal.
2. Connect an oscilloscope to Pin 5 of CN003 [A Board].
3. Enter into the ‘Service’ service menu.
4. Adjust the ‘Sub Colour’ data so that the Cyan, Magenta and
Blue colour bars are of equal levels as indicated below.
Same Level
B-Out Waveform
Tuner AGC Adjustment
Note:
There should be no need to adjust the AGC as this is pre-
adjusted during manufacture of the FRONTEND. If the AGC
does need adjustment then follow steps 1. to 4. below.
1. Receive a signal of 62dBuV / 75 ohm terminated via the tuner
antenna socket.
2. Connect a voltmeter to pin1 of TU101 [print side of A Board]
or to the AGC pin of CN001 [mount side of A Board].
3. Confirm that the AGC voltage is 3./- 0.3volts.
4. If adjustment is required, then re-adjust the AGC variable
resistor (located at the top rear of the FRONTEND) to obtain
a voltage of 3.5V +/- 0.3V.
1. Enter into the ‘Geometry’ service menu.
2. Select and adjust each item in order to obtain the optimum image.
[ Print side of A board ]
Deflection System Adjustment
V SIZE
V LIN
S CORRECTION
V CENTRE
H CENTRE
H SIZE
PIN AMP
PIN PHASE
CORNER PIN
V ANGLE
Y R T E M O E G
y t i r a e n i L - V
ll o r c S - V
k l B H - t f e L
k l B H - t h g i R
e l g n A - V
w o B - V
e r t n e C - H
e z i S - H
p m A - n i P
n i P - r e n r o C - U
n i P - r e n r o C - L
e s a h P n i P
e p o l S - V
e z i S - V
n o i t c e r r o C - S
e r t n e C - V
m o o Z - V
a t n e g a M
) 3 6 , 0 (
) 3 6 , 0 (
) 5 1 , 0 (
) 5 1 , 0 (
) 3 6 , 0 (
) 3 6 , 0 (
) 3 6 , 0 (
) 3 6 , 0 (
) 3 6 , 0 (
) 3 6 , 0 (
) 3 6 , 0 (
) 3 6 , 0 (
) 3 6 , 0 (
) 3 6 , 0 (
) 3 6 , 0 (
) 3 6 , 0 (
) 3 6 , 0 (
) 3 6 , 0 (
j d A
2 3
8
6
j d A
j d A
j d A
j d A
j d A
j d A
j d A
j d A
5 3
j d A
j d A
j d A
3 2
0 4