Sony DXC-LS1P, Инструкция по эксплуатации

Страница: 32 / 148

32
Adjusting and Setting with Menus
OUTPUT
Selects a video output signal of the 12-pin connector on the
rear panel of the camera control unit when the CMA-D2CE
camera adaptor (not supplied) is used.
Selection Function
VBS Selects the VBS output signal.
Y/C Selects the Y/C output signal.
BAUD RATE
Changes the baud rate of the RS-232C interface to any of
19200, 9600 or 4800.
SC PHASE
When locking the camera sync generator, use the “SC
PHASE” function to adjust the subcarrier phase. Adjust
roughly by setting to 0
°
or 180
°
and make fine adjustment
by adjusting the level within the range from 0 to 255. Press
the select button
ı
or
∫
to display desired value. Press both
buttons together to reset the values to 0.
SC 0/180
When locking the camera sync generator, use the “SC
0/180” function to adjust the subcarrier phase roughly.
H.PHASE
When locking the camera sync generator, you can use the
“H. PHASE” function to perfectly synchronize the camera
operation with the reference signal to the level of the
horizontal phase.
You can adjust the level within the range from 0 to 255.
Press the select button
ı
or
∫
to display desired value. Press
both buttons together to reset the values to 0.