Sony DWRS02D/14, Руководство по эксплуатации

Страница: 29 / 36

29 Troubleshooting
Troubleshooting
If you encounter a problem using this receiver, use the following checklist to find a solution.
For any problems with the transmitter or adapter, refer to the operating instructions supplied
with the respective device. If the problem persists, consult your Sony dealer.
Symptom Meanings Remedy
The receiver
does not turn
on. The receiver is not correctly
inserted into the slot of the
camcorder or the optional DWA-
01D/F01D wireless adapter. Insert the receiver until it is firmly
and completely in, and then secure
it with the mounting screws.
There is no
sound. The channel setting on the
transmitter is different from that
on the receiver. Use the same channel setting on
both the transmitter and receiver.
The transmitter is turned off. Check the power supply or battery
of the transmitter.
The setting of the encrypted
transmission function on the
receiver is different from that on
the transmitter. Confirm that the setting of the
encrypted transmission function is
the same on both the transmitter
and the receiver.
When the receiver is attached
through the optional DWA-01D/
F01D wireless adapter, the
setting of the sync signal is not
appropriate. Using the sync signal selection
(SYNC SOURCE) function, set the
sync signal to INTERNAL.
When an external sync signal is
used, confirm the connection of the
sync signal, and set to AUTO or
EXTERNAL.
The sound is
weak. The attenuation level on the
transmitter is too high. Set the attenuator on the
transmitter to an appropriate level.
The AES/EBU reference output
level is set to –36 dBFS LINEAR. Set the reference output level
according to the use (see page 18).
There is
distortion in
the sound. The attenuation level of the
transmitter is zero or too low. The input level of the transmitter is
extremely high. Adjust the
attenuation level on the transmitter
so that there is no distortion to the
sound.
A LINE level signal is being input
while the input level of the
transmitter set to MIC. Refer to the operating instructions
supplied with the transmitter and
set the input level to LINE.