Sony DWR-R02D, Руководство по эксплуатации

Страница: 16 / 45

16
Preparation
To stop DC power supply, turn off the connected external
power supply or disconnect the connected cable.
h
ANTENNA a/b OUT (antenna a/b output)
connectors (BNC-R)
These connectors output the signals input from the
ANTENNA a/b IN connectors. Using these connectors,
you can connect up to eight of DWR-R02D units in
cascade.
i
REM ANT (ST remote system antenna)
This is an external antenna for the ST remote system.
j
WORD SYNC IN/OUT (sync signal input/output)
connectors and 75
Ω
termination switch
When you want to synchronize digital output with an
external sync signal, input the external sync signal to the
WORD SYNC IN connector.
The sync signal input from the IN connector is output from
the OUT connector.
Set the 75
Ω
termination switch of only the DWR-R02D
unit at the end of the cascade connection to ON.
For details on connecting to the WORD SYNC connectors,
see “Connection Example of Word Clock and Audio” on
page 21.
Preparation
Rack Mounting
Use the EIA standard 19-inch rack (1U size) with a depth
of 350 mm to install the DWR-R02D.
To use the DWR-R02D without installing in
the rack
Attach the supplied four feet to the bottom of this unit, as
illustrated below.
To install the DWR-R02D in the rack, be sure to remove
the attached feet.
Rack
DWR-R02D
Screws
(+B M5 × 12)
Screws
(+B M5 × 12)
Foot
Attach the adhesive side of the feet to the circular
marks at the bottom of the unit.