DSX-GS900
13
Sony CONFIDENTIAL
For Authorized Servicer
Subwoofer Easy Connection
You can use a subwoofer without a power amplifier
when it is connected to a rear speaker lead.
To enable the connection, set [SUBW MODE] in
[SUBW DIRECT] to [1] to [3].
Note
Use a subwoofer with a 2 Ω impedance or 4 Ω to 8 Ω
impedance, and with adequate power handling
capacities to avoid damage.
Speaker Parallel Connection
When making the speaker parallel connection for a
high volume playback, be sure to:
– Set [SPKR LOAD] in [GENERAL] to [2 OHM].
Notes
ˎ
When using a subwoofer with dual voice coil, or using
a subwoofer by connecting the right and left rear
speaker leads, be sure to set [SPKR LOAD] in
[GENERAL] to [2 OHM].
ˎ
To exert the speaker’s potential, make the power
connection to the battery directly (page 12).
Front speaker
Subwoofer
FL
FR
RR
RL
Front speaker
(4 Ω to 8 Ω)
Rear speaker
(4 Ω to 8 Ω)
Subwoofer
(4 Ω to 8 Ω, dual voice
coil type)
To capture your voice during handsfree calling, you
need to install the microphone
ʕ
.
Cautions
ˎ
It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
ˎ
If airbags or any other shock-absorbing
equipment is in your car, contact the store where
you purchased this unit, or the car dealer, before
installation.
Notes
ˎ
When mounting on the dashboard, remove the visor
clip carefully from the microphone
ʕ
, then attach the
flat-mount base
ʖ
to the microphone
ʕ
.
ˎ
Before attaching the double-sided tape
ͪ
, clean the
surface of the dashboard with a dry cloth.
Installing the microphone
ͪ
ʕ
Clip (not supplied)
ʕ
ʖ
Installation
For Japanese cars, see “Mounting the unit in a
Japanese car” (page 15).
Mounting the unit with an installation kit
(not supplied)
You can use a commercially available double DIN
installation kit. Choose an installation kit with the
following panel frame size.
Larger than 172 mm × 97 mm (6
7
/
8
in
× 3
7
/
8
in) (w/
h), with an inner corner radius of less than 0.5 mm
(
1
/
32
in).
Note
Be sure to use the mounting screws
ʓ
.
Mounting the unit in the dashboard
CAUTION
Do not touch the left side of the unit when
removing from the dashboard. The heatsink on
the left side of the unit remains hot right after
use.
Larger than
97 mm (3
7
/
8
in)
Larger than
172 mm (6
7
/
8
in)
Installation kit (not supplied)
To dashboard/center console
ʓ
ʓ
When using the steering wheel remote
control
Installation of the connection cable RC-SR1 (not
supplied) is required before use.
1
To enable the steering wheel remote control,
select [STEERING]
q
[EDIT CUSTOM] to make the
registration.
When the registration completes, the steering wheel
remote control becomes available.
Notes on installing the connection cable RC-SR1 (not
supplied)
ˎ
Refer to the support sites on the back cover for
details, then connect each lead properly to the
appropriate leads. Making an improper connection
may damage the unit.
ˎ
Depending on the type of car, be sure to insulate the
unused leads with electrical tape for safety.
ˎ
Do not connect this cable when the steering wheel
remote control is not used.
ˎ
Consulting the dealer or an experienced technician
for help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [STRG
CTRL] in [STEERING] to [PRESET].
Using the wired remote control
Mounting the unit in a Japanese car
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult your
Sony dealer.
When mounting this unit to the preinstalled
brackets of your car, use the mounting screws
ʓ
in
the appropriate screw holes based on your car:
T for TOYOTA and N for NISSAN.
Note
To prevent malfunction, install only with the mounting
screws
ʓ
.
ʓ
To dashboard/center console
Parts supplied with
your car
ʓ
Bracket
Bracket
When replacing the fuse, be sure
to use one matching the
amperage rating stated on the
original fuse. If the fuse blows,
check the power connection and
replace the fuse. If the fuse blows
again after replacement, there
may be an internal malfunction. In such a case,
consult your nearest Sony dealer.
Fuse replacement
Fuse (15 A)
.
.
SYS SET
2019/10/17 22:00:30 (GMT+09:00)
