DSX-B700/B700W/B710D
10
Sony CONFIDENTIAL
For Authorized Servicer
SECTION 2
GENERAL
This section is extracted from
operating instruction.
(B700: US, CND/B700W)
Cautions
ˎ
Run all ground (earth) leads to a common
ground (earth) point.
ˎ
Do not get the leads trapped under a screw, or
caught in moving parts (e.g., seat railing).
ˎ
Before making connections, turn the car ignition
off to avoid short circuits.
ˎ
Connect the
yellow
and
red
power supply leads
only after all other leads have been connected.
ˎ
Be sure to insulate any loose unconnected leads
with electrical tape for safety.
ˎ
Choose the installation location carefully so that
the unit will not interfere with normal driving
operations.
ˎ
Avoid installing the unit in areas subject to dust,
dirt, excessive vibration, or high temperature,
such as in direct sunlight or near heater ducts.
ˎ
Use only the supplied mounting hardware for a
safe and secure installation.
Note on the power supply lead (yellow)
When connecting this unit in combination with other
stereo components, the amperage rating of the car
circuit to which the unit is connected must be higher
than the sum of each component’s fuse amperage
rating.
Note on installing in cars with a start-stop system
The unit may restart when starting the engine from
start-stop. In this case, turn off the start-stop system of
your car.
Mounting angle adjustment
Adjust the mounting angle to less than 30°.
Connection/Installation
*1 Not supplied
*2 Speaker impedance: 4 Ω to 8 Ω × 4
*3 RCA pin cord (not supplied)
*4 Depending on the type of car, use an adaptor for a
wired remote control (not supplied).
For details on using the wired remote control, see
“Using the wired remote control”.
*5 Whether in use or not, route the microphone input
cord such that it does not interfere with driving
operations. Secure the cord with a clamp, etc., if it is
installed around your feet.
For details on installing the microphone, see
“Installing the microphone”.
Connection
2
White
White/black striped
Gray
Black
Yellow
from a car antenna (aerial)*
6
Front speaker*
1
*
2
Rear speaker*
1
*
2
Gray/black striped
Green
Green/black striped
Purple
Purple/black striped
Red
*
3
*
3
*
3
Subwoofer*
1
Power amplifier*
1
For details, see “Making
connections”.
Satellite radio tuner*
7
(SiriusXM)*
1
3
*
5
from a wired remote control
(not supplied)*
4
Blue/white striped
Orange/white striped
(B700: US, CND)
*6 Depending on the type of car, use an adaptor (not
supplied) if the antenna (aerial) connector does not
fit.
*7 For more information on how to install the SiriusXM
Connect Vehicle tuner, consult the installation guide
included with the tuner.
(B700: US, CND)
ɞ
To a common ground (earth) point
First connect the black ground (earth) lead, then
connect the yellow and red power supply leads.
ɟ
To the +12 V power terminal which is
energized at all times
Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.
ɠ
To the +12 V power terminal which is
energized when the ignition switch is set to
the accessory position
If there is no accessory position, connect to the
+12 V power (battery) terminal which is
energized at all times.
Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.
ɡ
To the power antenna (aerial) control lead or
the power supply lead of the antenna (aerial)
booster
It is not necessary to connect this lead if there is
no power antenna (aerial) or antenna (aerial)
booster, or with a manually-operated telescopic
antenna (aerial).
To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers and a
power antenna (aerial). Connecting any other
system may damage the unit.
ɢ
To a car’s illumination signal
Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.
Making connections
Subwoofer Easy Connection
You can use a subwoofer without a power amplifier
when it is connected to a rear speaker lead.
Note
Use a subwoofer with an impedance of 4 Ω to 8 Ω, and
with adequate power handling capacities to avoid
damage.
Memory hold connection
When the yellow power supply lead is connected,
power will always be supplied to the memory
circuit even when the ignition switch is turned off.
Speaker connection
ˎ
Before connecting the speakers, turn the unit off.
Front speaker
Subwoofer
ˎ
Use speakers with an impedance of 4 Ω to 8 Ω,
and with adequate power handling capacities to
avoid damage.
SYS SET
2019/10/24 21:43:03 (GMT+09:00)
